Engineering » Page 88

Engineering

Motor control circuit conductors that extend beyond the motor control equipment enclosure shall have short-

circuit and ground-fault protection sized not greater than percent of the value specified in Table 310.15 (B)

(16) for 602 C conductors.

O a. 150

Ob. 300

O c. 400

O d. 100

Answer Answers (1)

Engineering

For three or more conductors, the required "percent fill" value for conduit and tubing is what %?

Answer Answers (1)

Engineering

An offshore oil rig will drill into the ocean floor which is located 1 mile below the water surface. Determine the pressure at that location (i. e. at 1 mile ocean depth). Could a human body withstand that pressure? What would happen to an unprotected, exposed person at that depth? (2360 psi)

Answer Answers (1)

Engineering

Example for strengthening mechanism in single-phase material A. Dispersion strengthening B. Precipitation hardening C. Fiber strengthening D. Strain hardening

Answer Answers (2)

Engineering

Explain with schematics the operating principle of solid state lasers.

Answer Answers (1)

Maximus Nielsen

Engineering

Geological process lead to melting

Answer Answers (1)

Nickolas Church

Engineering

How do you distinguish the difference between drag and lift forces?

Answer Answers (1)

Engineering

A 2-kg plastic tank that has a volume of 0.2 m3 is filled with liquid water. Assuming the density of water is 1000 kg/m3, determine the weight of the combined system. The weight of the combined system is N.

Answer Answers (1)

Engineering

The alignment readings for the front of a vehicle are shown above. Camber and toe are within specification, caster is not. Technician A says that with the current settings, the left front tire tread may wear on the inside edge. Technician B says that with the current settings, the vehicle may pull to the left. Who is right? A. A only B. B only C. Both A and B D. Neither A nor B

Answer Answers (1)

Engineering

Cómo se llama el componente, que permite abrir o cerrar un circuito eléctrico

What is the component called, which allows you to open or close an electrical circuit?

Answer Answers (1)

Engineering

An automobile engine consumes fuel at a rate of 22 L/h and delivers 55 kW of power to the wheels. If the fuel has a heating value of 44,000 kJ/kg and a density of 0.8 g/cm3, determine the efficiency of this engine.

Answer Answers (2)

Engineering

Use the writeln () method of the document object to display the user agent in a tag in the webpage. Hint: The userAgent property of the window. navigator object contains the user agent.

Answer Answers (1)

Engineering

A column has a 4.8 cm by 8.7 cm rectangular cross section and a height 4 mm. The column is fixed at both ends and has a lateral support at mid-height for the weak axis. The material has E = 200 GPa and ÏƒY = 250 MPa. a. The factor of safety for the column yielding is FS 1.5. What is the maximum load that can be applied based on the column yielding due to the normal stress? Assume the load is applied at the centroid of the section. Express your answer with appropriate units to three significant figures. b. The design is to have a factor of safety for buckling FS 2.5. What is the maximum load based on buckling in the strong axis of the column? Express your answer with appropriate units to three significant figures.

Answer Answers (1)

Jennifer Medina

Engineering

You are a technical writer for Landson Toy Company. Landson has just designed a new, more durable swing set for 6 - to 10-year-olds. What should you include in the Introduction to the swing-set installation guide?

Answer Answers (1)

Engineering

Describe the anodising process, with diagrams.

Answer Answers (1)