Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness. Technician B says that inner tie rod ends
can be most effectively checked for wear on an alignment rack with the vehicle's weight on the wheels and the locking pins removed from the turn
plates. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technician A and B
D. Neither Technician A nor B
Answers (2)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness. Technician B says that ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Consider a 50-mH inductor. a. Express the voltage across the inductor and then evaluate it at t = 0.25 s if iL (t) = 5e - 2t + 3te-2t - 2 A. Be certain to simplify your expression.
Answers (1)
A battery is an electromechanical device. a) - True b) - False
Answers (1)
A 600 MW coal-fired power plant has an overall thermal efficiency of 38%. It is burning coal that has a heating value of 12,000 Btu/lb, an ash content of 5%, a sulfur content of 3.0%, and a CO2 emission factor of 220lb/million Btu.
Answers (1)
Discuss the differences between conduction and convective heat transfer.
Answers (1)
Thin film deposition is a process where: a) - elemental, alloy, or compound thin films are deposited onto a bulk substrate! b) - Phosphatization is also applied c) - Zinc plating is also applied d) - None of the above
Answers (1)
New Questions in Engineering
Which of the following statements regarding piston rings is false? Select one: a. A compression ring prevents pressurized refrigerant from blowing past the piston into the crankcase. b.
Answers (1)
In solid rocket motor terminology, a sliver is: A. A basic geometric shape B. Leftover propellant C. A test article for propellant characterization D. A type of igniter
Answers (1)
Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness.
Answers (2)
Describe the three primary duties for engineer
Answers (1)
Q2: The average water height of an ocean area is 2.5 m high and each wave lasts for an average period of 7 s.
Answers (1)